EasyClick PC is an ideal option for glazing and roofing in Patios, Greenhouses, Carports, Pool Enclosures, Office Partitions and more, EasyClick PC is the perfect product for DIY. Available it a 250mm and 500mm wide panel EasyClick is perfect to replace the roofing on your tired old pergola. Easily retrofitted to structures designed for profiled sheeting with no additional support required.
Assembly of EasyClick PC is so simple that it can be installed with standard DIY tools. Cut panels to desired length, screw in place, snap in next panel and repeat, finish with aluminium U-channel. EasyClick is thermally efficient and offers high light transmission and filters 99% of the harmful UV rays, protecting patio furniture, vehicles, etc. from the harmful effects of the sun.
SHEET INFORMATION | ||
---|---|---|
COLOURS | WIDTH | THICKNESS |
Clear, Opal, Grey | 250mm or 500mm | 16mm |
LIGHT TRANSMISSION | ||
---|---|---|
COLOURS | EASYCLICK 250mm | EASYCLICK 500mm |
Clear | 80% | 77% |
Opal | 50% | 67% |
Grey | 40% | 10% |
Shade factors shown provide an indication of the heat absorbed or reflected by the EasyClick sheet. The 4 walls and hammered glass finish provide exceptional performance in comparison with single layered sheeting. Shade Factor Key 0 = Full Light, 10 = Full Shade |
SPANNING CAPACITY (BETWEEN PURLINGS) | ||
---|---|---|
MAX SPAN | EASYCLICK 250mm and 500mm PANEL |
1200mm |
The span between battens and supporters should not exceed the above measurements and have a minimum fall of 5 degrees. |
SHEET COVERAGE TABLE for 250mm PANEL | ||||
---|---|---|---|---|
1 SHEET |
2 SHEETS |
3 SHEETS |
4 SHEETS |
5 SHEETS |
250mm | 500mm | 750mm | 1000mm | 1250mm |
SHEET COVERAGE TABLE for 500mm PANEL | ||||
---|---|---|---|---|
1 SHEET |
2 SHEETS |
3 SHEETS |
4 SHEETS |
5 SHEETS |
500mm | 1000mm | 1500mm | 2000mm | 2500mm |
Please download the full EasyClick 250mm or 500mm brochure from the "EasyClick Info (PDFs)" drop-down menu below; these have the specific installation details for each product.
Only one side of the EasyClick sheet is UV protected, therefore ensure the sheeting is installed with the correct side facing up. Sheet ribs (flutes) must run vertically with the fall of the roof. Sheeting can be cut to length using a power saw fitted with a fine-tooth blade suitable for plastic. A craft knife can be used for cutting to width.
Please ensure the EasyClick End-Cap is installed with the drip-edge facing down.
Only use sealants that are 100% compatible with polycarbonate sheeting; suitable sealants are available from Ampelite. The use of incorrect sealants will void warranties. For installation in curved applications, please contact Ampelite.
EasyClick sheeting is a non-trafficable material. Sheets should be handled with care to avoid damage to the surface and fully support sheeting while cutting.
Polycarbonate sheeting is fully recyclable and can also be disposed of in a land fill.
Use only a soft brush and soapy water – no abrasives. To prevent possible staining, we recommend cleaning whenever bird soil is apparent.